![]() ![]() The two Amazon links below are affiliate links. Get 50% off your first order with my code: mfvjgnw | I buy lots of odds and ends here, so if you need some small item and don’t mind waiting, this can be a fun shop to check out. If you don’t check you might end up with pieces that are just a teeny bit too thick for the box/sliding lid to close perfectly flush. Just make sure to measure you materials as some boards labeled 3mm and 6mm are actually thicker/thinner than others of the same thickness. You can see an example below of how adding an extra layer or using a thicker inner grid will allow you to stack. ![]() Alternatively, you can cut the X’s and O’s from thinner material (like 1/16″) and stack that way. Now you can fit as many extra pieces as you need. This will make the middle thicker and then you can stack the pieces in. ![]() You could also just cut the middle layer from thicker material – like 1/4″/6mm (just make sure not to cut the pieces from 1/4″ too or you’re back to square one). ![]() To do that simply cut another “middle” grid layer (if doing the box style make sure you include the outer ring that’s used as the box lid’s edge so it closes flush – or don’t it’s your project). I got a few questions about this, and you can include it if you want. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |